PDF p. 1223 · 23-F-4
NOTE: Be careful not to scratch or damage the defogger wires with the tester probe.
- 1.
Check for voltage between the positive terminal and body ground with the ignition switch and defogger switch ON.
There should be battery voltage.
- If there is no voltage, check for:
- Faulty defogger switch.
- An open in the BLK/BLU wire.
- Poor ground (G401, G402, G501).
- If there is battery voltage, go to step 2.
- If there is no voltage, check for:

- 1. NEGATIVE TERMINAL
- 2. POSITIVE TERMINAL
- 2.
Check for continuity between the negative terminal and body ground.
If there is no continuity check for an open in the defogger ground wire.
- 3.
Touch the voltmeter positive probe to the halfway point of each defogger wire and the negative probe to the negative terminal.
There should be approximately 6V with the ignition switch and the defogger switch ON.
- If the voltage is as specified, the defogger wire is OK.
- If the voltage is not as specified, repair the defogger wire.
- If it is more than 6V, there is a break in the negative half of the wire.
- If it is less than 6V, there is a break in the positive half of the wire.
Defogger Wire Repair
NOTE: To make an effective repair, the broken section must be no longer than one inch.
- 1.Lightly rub the area around the broken section with fine steel wool, then clean it with alcohol.

- 1. OPEN
- 2. CELLOPHANE TAPE
- 3. BROKEN WIRE
- 2.Carefully mask above and below the broken portion of the defogger wire with cellophane tape.
- 3.Using a small brush, apply a heavy coat of silver conductive paint extending about 1/8” on both sides of the break. Allow 25 minutes to dry. Thoroughly mix the paint before use.

- 1. PAINT
- 4.Check for continuity in the repaired wire.
- 5.Apply a second coat of paint in the same way. Let it dry for three hours before removing the tape.