Workshop manual

Seat Belt Reminder System (KY and KQ models)

Control Unit Input Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1219 (manual page 23-E-25)

PDF p. 1219 · 23-E-25

  1. 1.
    Disconnect the 7P connector from the control unit.
  2. 2.
    Inspect the connector and socket terminals to make sure they are all making good contact.
    • If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system.
    • If the terminals look OK, make the following input tests at the connector.
      • If any test indicates a problem, find and correct the cause, then recheck the system.
      • If all the input tests prove OK, the control unit must be faulty, replace it.
Illustration: SEAT BELT ALARM UNIT; BLK; RED/BLU; YEL; WHT/BLU; Wire side of female terminals; 7P CONNECTOR
  1. 1. SEAT BELT ALARM UNIT
  2. 2. BLK
  3. 3. RED/BLU
  4. 4. YEL
  5. 5. WHT/BLU
  6. 6. Wire side of female terminals
  7. 7. 7P CONNECTOR
CavityWireTest conditionTest: Desired resultPossible cause if result is
not obtained
2BLKUnder all conditionsCheck for continuity to ground:♦Poor ground (G401, G402)
There should be continuity♦An open in the wire
3RED/BLUIgnition switch ON (II)Check for voltage to ground:♦Poor ground (G401, G402)
and driver’s seat beltThere should be 1V or less♦Faulty seat belt switch
switch unbuckled♦An open in the wire
4YELIgnition switch ON (II)Check for voltage to ground:♦Blown No. 6 (7.5A) fuse in
There should be battery voltagethe under-dash fuse/relay box
♦An open in the wire
7WHT/BLUUnder all conditionsCheck for voltage to ground:♦Blown No. 23 (7.5A) fuse in
There should be battery voltagethe under-dash fuse/relay box
♦An open in the wire