Workshop manual

Rear Fog Light (KG and KE models)

Control Unit Input Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1176 (manual page 23-D-10)

PDF p. 1176 · 23-D-10

  1. 1.
    Disconnect the 5P connector from the rear fog light control unit.
  2. 2.
    Inspect the connector and socket terminals to make sure they are all making good contact.
    • If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system.
    • If the terminals look OK, make the following input tests at the connector.
      • If any test indicates a problem, find and correct the cause, then recheck the system.
      • If all the input tests prove OK, the control unit must be faulty, replace it.
Illustration: REAR FOG LIGHT CONTROL UNIT; RED/BLU; BLK; RED/GRN; RED/YEL; Wire side of female terminals; 5P CONNECTOR
  1. 1. REAR FOG LIGHT CONTROL UNIT
  2. 2. RED/BLU
  3. 3. BLK
  4. 4. RED/GRN
  5. 5. RED/YEL
  6. 6. Wire side of female terminals
  7. 7. 5P CONNECTOR
CavityWireTest conditionTest: Desired resultPossible cause if result is not
obtained
1RED/BLUCombination lightCheck for voltage to ground♦Blown No. 44 (7.5A) fuse in
switch ONThere should be battery voltagethe under-dash fuse/relay box.
♦Faulty combination light switch
♦Faulty headlight relay 1
♦An open in the wire
2RED/YELUnder all conditionsCheck for continuity to ground:♦Poor ground (G401, G402,
There should be continuityG501)
♦Faulty rear fog light
♦Faulty rear fog light switch
indicator light
♦An open in the wire
3RED/GRNRear fog light switchCheck for continuity to ground:♦Poor ground (G401, G402)
ONThere should be continuity♦Faulty rear fog light switch
♦An open in the wire
5BLKUnder all conditionsCheck for continuity to ground:♦Poor ground (G401, 402)
There should be continuity♦An open in the wire