PDF p. 1039 · 21-4
Note the following items before troubleshooting a symptom:
- Check the engine coolant level, and allow the engine to warm up before troubleshooting.
- Any abnormality must be corrected before continuing the test.
- Because of the precise measurements needed, use a digital circuit tester when testing.
- Before performing any troubleshooting procedures check:
- Fuse No. 56 (40 A) in the under-hood fuse/relay box, and No. 11 (7.5 A) in the under-dash fuse/relay box
- Grounds No. G201, G401, G402
- Cleanliness and tightness of all connectors
| Symptom | Remedy | ||
|---|---|---|---|
| Hot air flow is low | Blower motor runs, but one or | Perform the procedures in the flowchart (See Page | |
| more speeds are inoperative | 21-5). | ||
| Blower runs properly | Check for the following: | ||
| ♦ | Clogged heater duct | ||
| ♦ | Clogged heater outlet | ||
| ♦ | Incorrect door position | ||
| No hot air flow | Blower motor does not run at | Perform the procedures in the flowchart (See Page | |
| all | 21-6) | ||
| Blower motor runs | Check for the following: | ||
| ♦ | Clogged heater duct | ||
| ♦ | Clogged heater outlet | ||
| ♦ | Clogged heater valve | ||
| ♦ | Faulty air mix door | ||
| ♦ | Heater valve cable adjustment (See Page 21-20) | ||
| ♦ | Air mix control cable adjustment (See Page | ||
| 21-20) | |||
| ♦ | Faulty cooling system thermostat (see section | ||
| 10) | |||
| ♦ | Clogged evaporator (with air conditioning) | ||
| ♦ | Frozen evaporator (with air conditioning) | ||
| Recirculation control doors do not change between fresh | Perform the procedures in the flowchart (See Page | ||
| and recirculate | 21-9) | ||