Workshop manual

Exterior Trim

Roof Spoiler Removal and Installation

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 1985 (manual page 20-36)

PDF p. 1985 · 20-36

NOTE:

  • Take care not to scratch the body and related parts.
  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  1. 1.
    Open the tailgate.
  2. 2.

    Remove the roof spoiler.

    -1Remove the caps from the roof spoiler, then remove the bolts (use Torx T-30 bit).
    -2Slide the roof spoiler rearward and remove it. The slide clips will stay on the roof side trim bracket.
    -3Disconnect the high mount brake light connector.
    -4Remove the slide clips from the roof side trim bracket.

: Bolt locations, 2

Illustration · Exterior Trim · Roof Spoiler Removal and Installation
  1. 3.
    Replace any damaged clips.
  2. 4.
    Install the slide clips on the roof spoiler.
  1. 1.
    CAP
  2. 2.
    HIGH MOUNT BRAKE LIGHT CONNECTOR
  3. 3.
    CLIPS
  4. 4.
    CLIP
  5. 5.
    CAP
  6. 6.
    SLIDE CLIP, 4
  7. 7.
    Forward
  8. 8.
    ROOF SIDE TRIM BRACKET
  9. 9.
    ROOF SPOILER
  10. 10.
    SLIDE CLIP, 4
  11. 11.
    ROOF SIDE TRIM BRACKET
  12. 12.
    ROOF SIDE TRIM
  13. 13.
    ROOF SPOILER
  1. 5.
    Connect the high mount brake light connector. Make sure the connector is plugged in properly.
  2. 6.
    Fit all the slide clips into the holes in the roof side trim bracket.