Workshop manual

Exterior Trim

Side Sill Panel Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1018 (manual page 20-82)

PDF p. 1018 · 20-82

  1. 1.

    Remove the side sill panel.

    -1Pull the inner fender back as necessary and remove the expansion clips.
    -2Slide the side sill panel forward and remove it. Side clips will stay in the body.
    -3Remove the side clips from the body.
    : Screw locations, 4 : Clip locations
Illustration: Forward; SIDE SILL PANEL; EXPANSION CLIP; INNER FENDER
  1. 1. Forward
  2. 2. SIDE SILL PANEL
  3. 3. EXPANSION CLIP
  4. 4. INNER FENDER
  1. 2.
    Replace any damaged clips.
  2. 3.
    Install the side clips on the side sill panel.
  3. 4.
    Hold the panel up and fit all the side clips into the holes in the body, then push on the panel until the clips snap into place.
  4. 5.
    Install all the expansion clips.
  5. 6.
    Install the inner fender.