PDF p. 974 · 20-38
- 1.Remove the glass (See Page 20-35).
- 2.Remove the main seal from the body.

- 1. MAIN SEAL
- 2. BODY
- 3. STEEL CORE
- 3.Clean the body bonding surface with a sponge dampened in alcohol. After cleaning keep oil, grease and water from getting on the body surface.
- 4.Apply sealer (CEMEDINE CS33061D or equivalent) to main seal.

- 1. MAIN SEAL
- 2. SEALER
- 5.Install the main seal as shown.

- 1. MAIN SEAL
- 2. CENTRE MARK
- 3. ALIGNMENT MARK
- 6.Scrape or wipe the excess adhesive off with putty knife or towel.
- 7.Leave for three hours.
- 8.Install the glass.
- 9.Check for water leaks. Do not use high-pressure water.