Workshop manual

Stall Speed

Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 636 (manual page 14-82)

PDF p. 636 · 14-82

NOTE: Stall speed test should be used for diagnostic purposes only.

  1. 1.
    Engage the parking brake and block the front wheels.
  2. 2.
    Connect a tachometer to the engine and start the engine.
  3. 3.
    Make sure the A/C switch is OF.
  4. 4.
    After the engine has warmed up to normal operating temperature (the radiator fan comes on), shift into D position.
  5. 5.
    Fully depress the brake pedal and accelerator for 6 to 8 seconds and note engine speed.
  6. 6.
    Allow two minutes for cooling, then repeat the test in L and R positions.

Stall Speed RPM in D position:

Specification: 2,500 rpm

Service Limit: 2,350 - 2,650 rpm

Stall Speed RPM in D position S mode, L and R positions:

Specification: 3,000 rpm

Service Limit: 2,800 - 3,100 rpm

TROUBLEPROBABLE CAUSE
Stall rpm high in D, L and R positions♦Low fluid level or ATF pump output
♦Clogged ATF strainer
♦PH regulator valve stuck closed
♦Slippage of forward clutch
♦Faulty start clutch
Stall rpm high in R position♦Slippage of reverse brake
♦Faulty start clutch
Stall rpm low in D, L and R positions♦Engine output low
♦Faulty start clutch
♦Stuck shift valve