Workshop manual

Ring Gear Bearing

Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 688 (manual page 14-131)

PDF p. 688 · 14-131

  1. 1.
    Remove the ring gear bearing.
Illustration: RING GEAR BEARING; RING GEAR
  1. 1. RING GEAR BEARING
  2. 2. RING GEAR
  1. 2.
    Install the new ring gear bearing until it bottoms in the ring gear, using the special tools as shown.
Illustration: HANDLE DRIVER, 07749-0010000; DRIVER ATTACHMENT, 32 x 35 mm, 07746-0010100; RING GEAR
  1. 1. HANDLE DRIVER, 07749-0010000
  2. 2. DRIVER ATTACHMENT, 32 x 35 mm, 07746-0010100
  3. 3. RING GEAR

Control Shaft Assembly

Removal/Installation

  1. 1.
    Remove the bolt and lock washer, then remove the roller.
  2. 2.
    Remove the control lever from the control shaft.
  3. 3.
    Remove the control shaft assembly.
  4. 4.
    Install the control shaft assembly in the transmission housing.
  5. 5.
    Install the control lever to the control shaft.
  6. 6.
    Install and tighten the bolt with a new lock washer.
Illustration: CONTROL SHAFT ASSEMBLY; TRANSMISSION HOUSING; CONTROL LEVER; LOCK WASHER, Replace.; 6 x 1.0 mm, 14 Nm (1.4 kgf/m, 10 lbf/ft).
  1. 1. CONTROL SHAFT ASSEMBLY
  2. 2. TRANSMISSION HOUSING
  3. 3. CONTROL LEVER
  4. 4. LOCK WASHER, Replace.
  5. 5. 6 x 1.0 mm, 14 Nm (1.4 kgf/m, 10 lbf/ft).