Workshop manual

Transfer Assembly

Disassembly

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 526 (manual page 13-52)

PDF p. 526 · 13-52

  1. 6.
    Secure the transfer housing in a bench vice with soft jaws. To prevent damage to the transfer housing, always use soft jaws or equivalent materials between the transfer housing and the vice.
  2. 7.
    Install the special tool on the companion flange, then loosen the transfer driven gear shaft locknut.
Illustration: COMPANION FLANGE HOLDER, 09RAB-0020000
  1. 1. COMPANION FLANGE HOLDER, 09RAB-0020000
  1. 8.
    Remove the transfer driven gear shaft locknut, conical spring washer, back-up ring, O-ring and companion flange.
Illustration: O-RING, Replace; BACK-UP RING; CONICAL SPRING WASHER, Replace; TRANSFER DRIVEN GEAR SHAFT LOCKNUT, Replace; COMPANION FLANGE
  1. 1. O-RING, Replace
  2. 2. BACK-UP RING
  3. 3. CONICAL SPRING WASHER, Replace
  4. 4. TRANSFER DRIVEN GEAR SHAFT LOCKNUT, Replace
  5. 5. COMPANION FLANGE
  1. 9.
    Remove the transfer driven gear shaft, then remove the transfer space from the transfer driven gear shaft.
Illustration: TRANSFER DRIVEN GEAR SHAFT; TRANSFER SPACER, Replace; TRANSFER HOUSING
  1. 1. TRANSFER DRIVEN GEAR SHAFT
  2. 2. TRANSFER SPACER, Replace
  3. 3. TRANSFER HOUSING
  1. 10.
    Remove the oil seal and the tapered roller bearing from the transfer housing.
Illustration: OIL SEAL, Replace; TAPERED ROLLER BEARING; TRANSFER HOUSING
  1. 1. OIL SEAL, Replace
  2. 2. TAPERED ROLLER BEARING
  3. 3. TRANSFER HOUSING