Workshop manual

Radiator

Engine Coolant Refilling and Bleeding

Supplement 2001 · source: HRV_Workshop_Manual.pdf, PDF pages 2153, 2154 (manual pages 10-2 to 10-3)

PDF p. 2153 · 10-2

  1. 1.
    Start the engine. Set the heater temperature control dial to maximum heat, then turn off the engine. Make sure the engine and radiator are cool to the touch.
  2. 2.
    Remove the radiator cap.
  3. 3.
    Loosen the drain plug and drain the coolant.
Illustration: DRAIN PLUG
  1. 1. DRAIN PLUG
  1. 4.
    Remove the drain bolt from the rear side of the cylinder block.
Illustration: WASHER, Replace; DRAIN BOLT, 83 Nm (8.5 kgf/m, 61 lbf/ft)
  1. 1. WASHER, Replace
  2. 2. DRAIN BOLT, 83 Nm (8.5 kgf/m, 61 lbf/ft)
  1. 5.
    Apply liquid gasket to the drain bolt threads, then reinstall the bolt with a new washer and tighten it securely.
  2. 6.
    Tighten the radiator drain plug securely.
  3. 7.
    Remove, drain and reinstall the coolant reservoir. Fill the tank halfway to the MAX mark with genuine Honda All Season Antifreeze/Coolant Type 2.
Illustration: MAX MARK
  1. 1. MAX MARK

PDF p. 2154 · 10-3

  1. 8.

    Pour genuine Honda All Season Antifreeze/Coolant Type 2 into the radiator up to the base of the filler neck.

    NOTE:

    • Always use genuine Honda All Season Antifreeze/Coolant Type 2. Using a non-Honda coolant can result in corrosion, causing the coolant system to malfunction or fail.
    • Genuine Honda All Season Antifreeze/Coolant Type 2 is a mixture of 50% antifreeze and 50% water. Pre-mixing is not required.

Engine Coolant Refill Capacity [including reservoir (0.4 l (0.42 US qt, 0.35 Imp. qt))]

M/T: 2.8 l (3.0 US qt, 2.5 Imp qt)

CVT: 3.0 I (3.2 US qt, 2,6 Imp qt)

Illustration · CVT: 3.0 I (3.2 US qt, 2,6 Imp qt)
  1. 9.
    Install the radiator cap loosely.
  2. 10.
    Start the engine and let it run until it warms up (the radiator fan comes on at least twice).
  3. 11.
    Turn off the engine. Check the level in the radiator and add genuine Honda All Season Antifreeze/Coolant Type 2 if needed.
  4. 12.
    Put the radiator cap on tightly, then run the engine again and check for leaks.