Workshop manual

Fuel Supply System

Fuel Filter Replacement

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 1888 (manual page 11-107)

PDF p. 1888 · 11-107

The fuel filter should be replaced whenever the fuel pressure drops below the specified value [260 - 310 kPa (2.7 - 3.2 kgf/cm2, 38 - 46 psi) with the fuel pressure regulator vacuum hose disconnected and pinched] after making sure that the fuel pump and the fuel pressure regulator are OK.

  1. 1.
    Relieve the pressure (See Page 11-106).
  2. 2.
    Remove the access panel from the floor.
  3. 3.
    Turn the ignition switch OFF, then disconnect the fuel pump 5P connector.
  4. 4.
    Disconnect the quick-connect fittings from the fuel pump.
  5. 5.
    Remove the bolts, and the fuel pump assembly.
Illustration: 4 Nm (0.4 kgf/m, 3 lbf/ft); BASE GASKET Replace.
  1. 1. 4 Nm (0.4 kgf/m, 3 lbf/ft)
  2. 2. BASE GASKET Replace.
  1. 6.
    Remove the bracket, the fuel gauge sending unit, the hose, and the wire harness from the fuel filter.
Illustration: FUEL SENDING UNIT; FUEL FILTER; WIRE HARNESS; TERMINAL; FUEL PUMP; BRACKET; SUCTION FILTER; BRACKET; SUCTION FILTER; FUEL PUMP; TAB; CLAMP
  1. 1. FUEL SENDING UNIT
  2. 2. FUEL FILTER
  3. 3. WIRE HARNESS
  4. 4. TERMINAL
  5. 5. FUEL PUMP
  6. 6. BRACKET
  7. 7. SUCTION FILTER
  8. 8. BRACKET
  9. 9. SUCTION FILTER
  10. 10. FUEL PUMP
  11. 11. TAB
  12. 12. CLAMP
  1. 7.
    When connecting the fuel pump, make sure the connection is secure and the suction filter is firmly connected to the fuel pump.
  2. 8.
    Install the part in the reverse order of removal with a new base gasket, then checking, these items:
    • When connecting the wire harness, make sure the connection is secure and the terminal is firmly locked into place.
    • Check that the tab of the clamp does not interfere with the wire harness.
    • Do not push the lower part of the suction filter.
    • When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.