Workshop manual

Rocker Arms and Shafts

Clearance Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 259 (manual page 6-20)

PDF p. 259 · 6-20

Measure both the intake rocker shaft and exhaust rocker shaft.

  1. 1.
    Measure the diameter of shaft at the first rocker location.
Illustration: Surface should be smooth.; MICROMETER
  1. 1. Surface should be smooth.
  2. 2. MICROMETER
  1. 2.
    Zero the gauge to the shaft diameter.
Illustration: MICROMETER; CYLINDER BORE GAUGE
  1. 1. MICROMETER
  2. 2. CYLINDER BORE GAUGE
  1. 3.

    Measure inside diameter of rocker arm and check for out-of-round condition.

    Rocker Arm-to-Shaft Clearance:

    Standard (New):

    Intake:0.017 - 0.050 mm
    (0.0007 - 0.0020 in)
    Exhaust:0.018 - 0.054 mm

    (0.0007 - 0.0021 in) Service Limit: 0.08 mm (0.003 in)

Illustration: Inspect rocker arm face for wear.
  1. 1. Inspect rocker arm face for wear.
  1. 4.
    Repeat for all the rockers.
    • If the clearance is over the service limit, replace the rocker shaft and all over tolerance rocker arms.